B9Creator Home Sensors Test


Remove the Vat to prevent potential pinch damage.


  1. Go to Settings>Printer Calibrations>Functional Printer and complete Step 1 "Command here to command the printer to locate the Home sensor (Arm and Vat will Move!)" after Step 1 is complete select "Cancel".
  2. Using the Z toggle switch, move the Z blade so that it is not inside the sensor. Activate the Toggle switch to move the blade down toward the sensor and at the same time insert a piece of paper between the blades of the home sensor and immediately remove the paper. Proper sensor operation is verified if the Z motor reverses direction.
  3. Using the X toggle switch to move the X red table away (Left) from the X home sensor. Activate the toggle switch to move the blade or platform toward the sensor and at the same time insert a piece of paper between the blades of the home sensor and immediately remove the paper.
  4. Proper operation is the table will reverse directions as soon as the paper is inserted into the sensor.
  5. Repeat the test to validate the results. If proper operation is observed Go to Settings>Printer Calibrations>Functional Printer and complete all Steps.
  6. If improper operation is observed report to Tech Support.